Products
-
Industrial wastewater treatment
-
Fiberglass Cooling Tower Series
-
Industrial combined concrete structure countercurrent square hollow tower
-
Industrial combined steel structure countercurrent square hollow tower
-
Industrial combined concrete structure cross-flow square tower
-
Industrial combined concrete structure countercurrent turbid water square tower
-
Industrial combined concrete structure counter-flow square tower
-
Standard combined steel structure countercurrent square tower
-
Industrial combination steel structure countercurrent turbid water square tower
-
Industrial combined steel structure countercurrent square tower
-

FJS type dual flow mechanical filter
- Commodity name: FJS type dual flow mechanical filter
- Description
-
Introduction
Mechanical filters, also known as pressure filters, are an important component of the pre-treatment and water purification system for pure water preparation. They are made of steel lined rubber or stainless steel, and can be divided into natural quartz sand filters, multi-media filters, activated carbon filters, manganese sand filters, etc. according to the different filtering media. They can be divided into single flow filters and double flow filters according to the water inlet method, and can be used in combination or separately depending on the actual situation.
Introduction
The inlet of the filter material of the dual flow mechanical filter is divided into two paths, one enters from the upper part of the filter material, and the other enters from the lower part of the filter material. The filtered effluent is discharged by the middle drainage device, which is located in the filter material layer 70cm away from the surface of the filter material.
Scope ofApplication
This filtration equipment is mainly used to remove suspended solids, sediment, iron, manganese, and agglomerated particles in raw water, as well as adhesive colloidal particles that cannot be removed by sedimentation methods.
Specification and model
External dimensions(mm)
Maximum water output(t/h)
Working pressure(MPa)
Height of quartz sand cushion layer(mm)
FJS-200
φ2000×4515
47.1
≤0.6
2000
FJS-250
φ2500×5115
74
≤0.6
2200
FJS-300
φ3000×5200
106
≤0.6
2200
Related Products
Welcome your message consultation
Our staff will contact you within 24 hours (working days). If you need other services, please call the service hotline: +86-510-87877888